Showing posts with label proximity. Show all posts
Showing posts with label proximity. Show all posts

29 December 2011

📉Graphical Representation: Proximity (Just the Quotes)

"If a chart contains a number of series which vary widely in individual magnitude, optical distortion may result from the necessarily sharp changes in the angle of the curves. The space between steeply rising or falling curves always appears narrower than the vertical distance between the plotting points." (Rufus R Lutz, "Graphic Presentation Simplified", 1949)

"First, it is generally inadvisable to attempt to portray a series of more than four or five categories by means of pie charts. If, for example, there are six, eight, or more categories, it may be very confusing to differentiate the relative values portrayed, especially if several small sectors are of approximately the same size. Second, the pie chart may lose its effectiveness if an attempt is made to compare the component values of several circles, as might be found in a temporal or geographical series. In such case the one-hundred percent bar or column chart is more appropriate. Third, although the proportionate values portrayed in a pie chart are measured as distances along arcs about the circle, actually there is a tendency to estimate values in terms of areas of sectors or by the size of subtended angles at the center of the circle." (Calvin F Schmid, "Handbook of Graphic Presentation", 1954)

"In form, the ratio chart differs from the arithmetic chart in that the vertical scale is not divided into equal spaces to represent equal amounts, but is divided logarithmically to represent percentages of gain or loss. On the arithmetic chart equal vertical distances represent equal amounts of change; on the ratio chart equal vertical distances represent equal percentages of change." (Walter E Weld, "How to Chart; Facts from Figures with Graphs", 1959)

"Pie charts have weaknesses and dangers inherent in their design and application. First, it is generally inadvisable to attempt to portray more than four or five categories in a circle chart, especially if several small sectors are of approximately the same size.  It may be very confusing to differentiate the relative values. Secondly, the pie chart loses effectiveness if an effort is made to compare the component values of several circles, as might occur in a temporal or geographical series. [...] Thirdly, although values are measured by distances along the arc of the circle, there is a tendency to estimate values in terms of areas by size of angle. The 100-percent bar chart is often preferable to the circle chart's angle and area comparison as it is easier to divide into parts, more convenient to use, has sections that may be shaded for contrast with grouping possible by bracketing, and has an easily readable percentage scale outside the bars." (Anna C Rogers, "Graphic Charts Handbook", 1961)

"The fact that index numbers attempt to measure changes of items gives rise to some knotty problems. The dispersion of a group of products increases with the passage of time, principally because some items have a long-run tendency to fall while others tend to rise. Basic changes in the demand is fundamentally responsible. The averages become less and less representative as the distance from the period increases." (Anna C Rogers, "Graphic Charts Handbook", 1961)

"There are several classes of flowcharts used in recording study data in the Workbook. The purpose of any chart; of course, is to clarify and to make the information more understandable. One of these types of charts is a Process Flow Chart. It concerns itself with the flow of physical materials, including documents, through a system, especially in terms of distance and time. It is most useful in analyzing some of the cost and benefit factors for existing and proposed systems. System flowcharts [...] have been called the analyst's 'shorthand'. They can be forms-oriented or task-oriented. These flowcharts are not only the primary way of recording data pertinent to the current system, but are used for developing and displaying the new system as well. Later, in the implementation phase, program flowcharts, a fundamental tool of programming, would be developed." (Robert D Carlsen, "The Systems Analysis Workbook: A complete guide to project implementation and control", 1973)

"The circle graph, or pie chart, appears to simple and 'nonstatistical', so it is a popular form of presentation for general readers. However, since the eye can compare linear distances more easily and accurately than angles or areas, the component parts of a total usually can be shown more effectively in a chart using linear measurement." (Peter H Selby, "Interpreting Graphs and Tables", 1976)

"The plotted points on a graph should always be made to stand out well. They are, after all, the most important feature of a graph, since any lines linking them are nearly always a matter of conjecture. These lines should stop just short of the plotted points so that the latter are emphasised by the space surrounding them. Where a point happens to fall on an axis line, the axis should be broken for a short distance on either side of the point." (Linda Reynolds & Doig Simmonds, "Presentation of Data in Science" 4th Ed, 1984)

"When magnitudes are graphed on a logarithmic scale, percents and factors are easier to judge since equal multiplicative factors and percents result in equal distances throughout the entire scale." (William S Cleveland, "The Elements of Graphing Data", 1985)

"If a distribution were perfectly symmetrical, all symmetry-plot points would be on the diagonal line. Off-line points indicate asymmetry. Points fall above the line when distance above the median is greater than corresponding distance below the median. A consistent run of above-the-line points indicates positive skew; a run of below-the-line points indicates negative skew." (Lawrence C Hamilton, "Regression with Graphics: A second course in applied statistics", 1991)

"Visually, skewed sample distributions have one 'longer' and one 'shorter' tail. More general terms are 'heavier' and 'lighter' tails. Tail weight reflects not only distance from the center" (tail length) but also the frequency of cases at that distance" (tail depth, in a histogram). Tail weight corresponds to actual weight if the sample histogram were cut out of wood and balanced like a seesaw on its median" (see next section). A positively skewed distribution is heavier to the right of the median; negative skew implies the opposite." (Lawrence C Hamilton, "Regression with Graphics: A second course in applied statistics", 1991)

"If you want to show the growth of numbers which tend to grow by percentages, plot them on a logarithmic vertical scale. When plotted against a logarithmic vertical axis, equal percentage changes take up equal distances on the vertical axis. Thus, a constant annual percentage rate of change will plot as a straight line. The vertical scale on a logarithmic chart does not start at zero, as it shows the ratio of values" (in this case, land values), and dividing by zero is impossible." (Herbert F Spirer et al, "Misused Statistics" 2nd Ed, 1998)

"Distance and detection also play a role in our ability to decode information from graphs. The closer together objects are, the easier it is to judge attributes that compare them. As distance between objects increases, accuracy of judgment decreases. It is certainly easier to judge the difference in lengths of two bars if they are next to one another than if they are pages apart." (Naomi B Robbins, "Creating More effective Graphs", 2005)

"[…] an outlier is an observation that lies an 'abnormal' distance from other values in a batch of data. There are two possible explanations for the occurrence of an outlier. One is that this happens to be a rare but valid data item that is either extremely large or extremely small. The other is that it isa mistake – maybe due to a measuring or recording error." (Alan Graham, "Developing Thinking in Statistics", 2006)

"[...] without conscious effort, the brain always tries to close the distance between observed phenomena and knowledge or wisdom that can help us survive. This is what cognition means. The role of an information architect is to anticipate this process and generate order before people’s brains try to do it on their own." (Alberto Cairo, "The Functional Art", 2011)

"The tricky part is that there aren’t really any hard- and- fast rules when it comes to identifying outliers. Some economists say an outlier is anything that’s a certain distance away from the mean, but in practice it’s fairly subjective and open to interpretation. That’s why statisticians spend so much time looking at data on a case-by-case basis to determine what is - and isn’t - an outlier." (John H Johnson & Mike Gluck, "Everydata: The misinformation hidden in the little data you consume every day", 2016)

"Charts abstract information. They make it easier to see patterns at a distance, compare, and extrapolate. Icon encodings are graphical elements that are often used to visually represent the semantic meaning of marks for categorical data. Assigning meaningful icons to display elements helps the user perceive and interpret the visualization easier." (Vidya Setlur & Bridget Cogley, "Functional Aesthetics for data visualization", 2022)

Related Posts Plugin for WordPress, Blogger...

About Me

My photo
Koeln, NRW, Germany
IT Professional with more than 24 years experience in IT in the area of full life-cycle of Web/Desktop/Database Applications Development, Software Engineering, Consultancy, Data Management, Data Quality, Data Migrations, Reporting, ERP implementations & support, Team/Project/IT Management, etc.